法国POWERSONIC蓄电池现货供应

　How to connect a battery in Series?

　　The positive terminal of the first battery is connected to thenegative terminal of the second battery, the positive terminal ofthe second is connected to the negative of the third, etc. Thevoltage of the assembled battery is the sum of the battery voltagesof the individual batteries. So the batteries are connected: + to -to + to - to + to -, etc. The capacity of the battery isunchanged.

　　How to connect a battery in Parallel?

　　The positive terminal of the first battery is connected to thepositive terminal of the second battery, the positive terminal ofthe second is connected to the positive of the third, etc. and Thenegative terminal of the first battery is connected to the negativeterminal of the second battery, the negative terminal of the secondis connected to the negative of the third, etc. So the batteriesare connected: + to + to + and - to - to -. In this configuration,the capacity is the sum of the capacities of the individualbatteries and voltage is unchanged. For example, if you take 5 6V10AH batteries and connect the batteries in series, you would endup with a battery array that is 30 Volts and 10AH. If you connectthe batteries in parallel, you would end up with a battery arraythat is 6 Volts and 50AH. By the way, this is how ordinary autobatteries are made. 6 2volt cells are put in series to give 12vbattery and the 6 cells are just enclosed in one case. Many ni-cadbatteries are done the same way.

　　POWER SONIC蓄电池应用领域与分类:

　　◆免维护无须补液；<UPS不间断电源；

　　◆内阻小，大电流放电性能好；<消防备用电源；

　　◆适应温度广；<安全防护报警系统；

　　◆自放电小；<应急照明系统；

　　◆使用寿命长；<电力，邮电通信系统；

　　◆荷电出厂，使用方便；<电子仪器仪表；

　　◆安全防爆；<电动工具,电动玩具；

　　◆独特配方，深放电恢复性能好；<便携式电子设备；

　　◆无游离电解液，侧倒仍能使用；<摄影器材；

　　PS andPSH-Series General Purpose used for :

　　Emergency Lighting

　　Burglar/Fire Alarms

　　Data Centers

　　Solar and Alternative Energy

　　Portable Communications

　　Wind Turbines

　　Robotics

　　Remote Monitoring

　　Portable Video Equipment

　　Portable Lighting

　　Photographic Equipment

　　Scientific Instruments

　　Test and Measuring Equipment

　　and much more...

　　PG-Long Life and PHR-High Rate Series used for :

　　Communication & Telecom Systems

　　UPS - Uninteruptible Power Supplies

　　Power Station Applications

　　Remote Area Power Generation

　　Remote Access Devices

　　Can I take a wheelchair, scooter or other equipment that ispowered by a sealed AGM or Gel battery on a airplane or cruiseship?

　　Yes. There should be no problem, the battery is considerednon-spillable, non-hazardous, since it is a absorbed glass matdesign. These sealed lead acid valve regulated (VRLA) batteries areclassified as "Battery, wet non-spillable, not subject toregulations" by DOT and IMO. By IATA they are classified as "Notrestricted for air transport" and they are in compliance withIATA/ICAO special provision A67. For the gelled electrolytebatteries, they are classified as "Battery, wet, filled with acid,UN2794, Class 8". They can be legally shipped via air with specialpackaging etc.

　　How do I Jump Start my Battery using booster cables?

　　WARNING-BATTERIES PRODUCE EXPLOSIVE GASES. These instructions aredesigned to minimize the explosion hazard. Keep sparks, flames andcigarettes away from batteries at all times. Both batteries shouldbe of the same voltage (6, 12, etc.).

　　SAFE BOOSTER CABLE OPERATION When jump starting, always wearproper eye protection and never lean over the battery. Do not jumpstart a damaged battery; inspect both batteries before connectingbooster cables. Be sure vent caps are tight and level. Be sure thatthe vehicles are not touching and that both ignition switches arein the "OFF" position. Turn off all electrical equipment (radio,defroster, windshield wipers, lights, etc.)