Victron CentaurCharger 12V/30A(3) 120-240V
TheCentaur battery charger features auto-ranging input covering90-265VAC 50/60Hz input meaning they can be used anywhere in theworld.
Crucially, and unlike many other products that state universalinput, the Centaur battery charger will maintain full outputpower.
Other featuresinclude:
Three isolated outputs to simultaneously charge 3 battery banks.Each output is capable to supply the full rated current.
Aluminium epoxy powder coated cases with drip shield andstainless steel fixings withstand the rigors of anadverseenvironment: heat, humidity and salt air.
Circuit boards are protected with an acrylic coating for maximumcorrosion resistance.
Temperature sensors ensure that power components will alwaysoperate within specified limits, if needed by automatic reductionof output current under extreme environmental conditions.
The chargers also accept a 90-400 V DC supply.
Three-stage charging, withtemperature compensation
The Centaur charges at bulk rate until the output has reduced to70% of the rated Amps, at which a 4 hour timer begins. After thetimed period the charger switches to float rate.
An internal temperature sensor is used to compensate the chargevoltage with – 2 mV/ºC (– 1 mV/ºF) per cell.
A DIP switch is available to select the optimum charge/floatvoltages for Flooded Lead-acid, Gel or AGM batteries
| Nominal Voltage | 12 Volt |
| Charging Voltage | 14.3 V |
| Charging Current | 30 A |
| Charger Type | 3 Stage IUoU |
| Battery Capacity Range | 120 - 300 Ah |
| Protection category | IP20 |
| Dimensions (mm) H x W x D | 355 x 215 x 110 |
| Operating temperature | -20ºC to +60ºC |